電磁弁
  • 技術データ
  • 製品説明
  • 性能曲線
  • 技術リファレンス
  • ファイル

Note: Data may vary by configuration. See CONFIGURATION section.

Cavity 20M-2
Rated Flow 10.57 gpm 40 L/min
Maximum Operating Pressure 5000 psi 350 bar
Fluid Temperature Range -40 to 120 ℃ (-40 to 248 ℉)
Maximum Leakage Approximtately 0.15 cc/min (3 drops/min) at 5000 psi 0.15 cc/min (3 drops/min) at 350 bar
Salt Spray Test to DIN EN ISO 9227:2017-07 Exceed 1000 Hours
Solenoid Valve Hex Size 15/16 in. 24 mm
Solenoid Valve Installation Torque 29 - 38 lbf-ft 39 - 51 Nm
Locknut Torque 1.5 -2 lbf-ft 2 - 3 Nm
Weight 0.29 lbs (Z=N), 0.31 lbs (Z=P, T) 0.13kg (Z=N), 0.14 kg (Z=P, T)
Mounting Position Unrestricted
Coil Type EC-04W
Supply Voltage 90% of nominal
Power Consumption 20W
This is a pilot-operated, poppet type, 2-way 2-position, normally open solenoid valve, which uses to as blocking or load holding device in high pressure application. This valve is similar to check valve when energized. Allow free flow from port 1 to port 2 and block flow from port 2 to port 1. In de-energized condition, this valve is allowed flow from port 2 to port 1 but it is difficult to pass that flow from port 1 to port 2. If you need bi-directional flow, please refer to EP-20M-2A-06-Z-05.

  • Continuous-duty rated coil.
  • Efficient wet-armature construction.
  • Working parts are heat-treated and high-precision ground to increase hardness for long life and essentially zero leakage.
  • A variety of seal kit materials for different applications, see seals information under Technical Reference.
  • Winner's cartridges pressure rating tested to the standard of the NFPA specification T2.6.1 and the fatigue rating's assurance and verification level is "90/90".
  • WINNERcoat® Zinc-Nickel Plating is salt spray tested in accordance with DIN EN ISO 9227 for up to 1000 hours.
  • Winner guarantees that all products performance a 100% functional test before shipment.
  • Note: The control option " Z=T " can only be used for emergency or test use. Please keep at the normal operational position after turning counterclockwise. A larger force is required for downward push during high-pressure operations, please contact Winner's sales department.
                                                  

The performance curve or data is only for reference, as customers' using condition, pressure, flow, hydraulic fluid viscosity, cleanliness, temperature and so on are different, the curve or data will be different.