電磁弁
  • 技術データ
  • 製品説明
  • 性能曲線
  • 技術リファレンス
  • ファイル

Note: Data may vary by configuration. See CONFIGURATION section.

Cavity 08W-2
Rated Flow 5.28 gpm 20 L/min
Maximum Operating Pressure 3600 psi 250 bar
Fluid Temperature Range -40 to 120 ℃ (-40 to 248 ℉)
Maximum Leakage Approximately 0.15 cc/min (3 drops/min) at 5000 psi 0.15 cc/min (3 drops/min) at 350 bar
Salt Spray Test to DIN EN ISO 9227:2017-07 Exceed 1000 Hours
Solenoid Valve Hex Size 15/16 in. 24 mm
Solenoid Valve Installation Torque 29 - 38 lbf-ft 39 - 51 Nm
Locknut Torque 2 - 3 lbf-ft 3 - 4 Nm
Weight 0.29 lbs 0.13 kg
Mounting Position Unrestricted
Coil Type EC-04W
Supply Voltage 90% of nominal
Power Consumption 20W
This is a pilot-operated, poppet type, 2-way 2-position, normally closed solenoid valve, which uses to as blocking or load holding device. This valve is similar to check valve when de-energized. Allow free flow from port 1 to port 2 and block flow from port 2 to port 1. In energized condition, this valve is allowed flow from port 2 to port 1 but it is difficult to pass that flow from port 1 to port 2. The fast-acting solenoid valve needs a minimum pressure to lift the poppet. Because this valve is made by adding an extra spring between the armature and the poppet. When the coil de-energizes, the poppet quickly reseats and blocks the flow.

  • Continuous-duty rated coil.
  • Efficient wet-armature construction.
  • Please note the pull force and without crooked direction.
  • This design allows faster response times with very small flow or even virtually zero flow.
  • Working parts are heat-treated and high-precision ground to increase hardness for long life and essentially zero leakage.
  • A variety of seal kit materials for different applications, see seals information under Technical Reference.
  • Winner's cartridges pressure rating tested to the standard of the NFPA specification T2.6.1 and the fatigue rating's assurance and verification level is "90/90".
  • IMPORTANT: Maximum operating pressure MUST never be exceeded, since this valve tends to open at pressures over 300 bar.
  • The solenoid valve is actuated by a cable mechanism. This allows the valve to be remotely operated without the need for direct physical contact with the valve itself.
  • WINNERcoat® Zinc-Nickel Plating is salt spray tested in accordance with DIN EN ISO 9227 for up to 1000 hours.
  • Winner guarantees that all products performance a 100% functional test before shipment.
                              

The performance curve or data is only for reference, as customers' using condition, pressure, flow, hydraulic fluid viscosity, cleanliness, temperature and so on are different, the curve or data will be different.