カートリッジ弁
  • 技術データ
  • 製品説明
  • 性能曲線
  • 技術リファレンス
  • ファイル

Note: Data may vary by configuration. See CONFIGURATION section.

Cavity 11A-3
Rated Flow 5.28 gpm 20 L/min
Maximum Operating Pressure 5000 psi 350 bar
Valve Hex Size 7/8 in. 22.22 mm
Valve Installation Torque 30 - 37 lbf-ft 40 - 50 Nm
Weight 0.55 lbs (without coil), 1.08 lbs (with coil) 0.25 kg (without coil), 0.49 kg (with coil)
Linearity (with Dither) <2%
Repeatibility (with Dither) <2%
Hysteresis (with Dither) <4%
Hysteresis with DC Input <8%
Coil EC-19A
Power Consumption 22W
This is a direct-acting, spool-type, electro-proportional reducing/relieving valve with improved dynamic response. The valve reduces high primary pressure at the inlet to a constant reduced pressure at port 2, while allowing full flow relief from port 2 to the tank at port 1. When operating in reducing mode, the valve allows flow from port 1 to port 3 at a specified pressure setting. By increasing the coil current, the reduced pressure at port 1 can be proportionally increased. If the pressure at port 1 exceeds the coil-induced setting, the valve will relieve the pressure to port 3. During the transition between reducing and relieving, the valve closes to minimize oil consumption. 

  • US patent US9234605.
  • This valve is direct-acting with an essentially zero-leakage design, making it suitable for brake circuit applications.
  • If you would like to adjust the pressure by your selves, any technical questions, please feel free to consult with Winner sales department.
  • When the inlet pressure reaches 210 - 350 bar (3000 - 5000 psi), it is recommended to maintain a minimum reduced pressure of 30 bar (450 psi) at port 1 for optimal control.
  • The maximum valve leakage is approximately 20 cc/min. Leakage specified is out of port 3 with a supply pressure of 210 bar (3000 psi) and the valve set at mid-range.
  • If your operation requires a wide range of settings, such as Y=1000, 15000, 2100 or 3500, and the need to control pressure below 10 bar (150 psi), please contact the Winner sales department.
  • This valve can operate under 1 bar; however, please note that the back pressure at port 3 directly affects the valve setting at a 1:1 ratio.
  • Working parts are heat-treated and high-precision ground to increase hardness for long life.
  • A variety of seal kit materials for different applications, see seals information under Technical Reference.
  • Winner's cartridges pressure rating tested to the standard of the NFPA specification T2.6.1 and the fatigue rating's assurance and verification level is "90/90".
  • WINNERcoat® Zinc-Nickel Plating is salt spray tested in accordance with DIN EN ISO 9227 for up to 1000 hours.
  • Winner guarantees that all products performance a 100% functional test before shipment.