カートリッジ弁
  • 技術データ
  • 製品説明
  • 性能曲線
  • 関連製品
  • 技術リファレンス
  • ファイル

Note: Data may vary by configuration. See CONFIGURATION section.

Cavity 11A-3
Rated Flow 15.85 gpm 60 L/min
Maximum Operating Pressure 5000 psi 350 bar
Valve Hex Size 7/8 in. 22.22 mm
Valve Installation Torque 30 - 37 lbf-ft 40 - 50 Nm
Adjustment Screw Internal Hex Size 5/32 in. 4 mm
Locknut Hex Size 9/16 in. 14.27 mm
Locknut Torque 6 - 7 lbf-ft 9 - 10 Nm
Response Time-Typical 10 ms
Maximum Leakage Approximately 33 cc/min at 1000 psi 33 cc/min at 70 bar
Weight 0.33 lbs (Z=L) 0.15 kg (Z=L)
This is a pilot-operated, balanced piston, ventable relief valve. It blocks flow from port 1 to port 2 until sufficient pressure is applied to port 1 to pilot-open the spool, allowing a flow path from port 1 to port 2. This flow through the vent causes a pressure imbalance, opening the main section and dumping the pump at minimum pressure drop. The valve includes a vent port (port 3) that connects the main piston to the pilot stage, allowing remote control in pump unloading application by other pilot valves, 2-way valves or proportional relief valves (PRB8A) and other valves. This valve features accurate pressure control, quiet and smooth operation, and a moderately fast response.

  • Maximum pressure can be accepted at port 2 but it is necessary to install double back-up rings to valve for cross port relief circuit application. Leakage of spool should be concerned.
  • The maximum leakage is approximately 33 cc/min at 70 bar (1000 psi).
  • When the pressure drop across the relief valve is high, cavitation can easily occur, leading to noise and manifold erosion. If this is a concern, please refer to the balanced poppet type RV-11A-3G-Y-Z.
  • Back pressure at port 2 (tank port) is added directly to the valve setting in a 1:1 ratio.
  • This valve is not proper to use in load holding applications due to spool leakage.
  • Working parts are heat-treated and high-precision ground to increase hardness for long life.
  • A variety of seal kit materials for different applications, see seals information under Technical Reference.
  • Winner's cartridges pressure rating tested to the standard of the NFPA specification T2.6.1 and the fatigue rating's assurance and verification level is "90/90".
  • WINNERcoat® Zinc-Nickel Plating is salt spray tested in accordance with DIN EN ISO 9227 for up to 1000 hours.
  • Winner guarantees that all products performance a 100% functional test before shipment. 
Pilot Capacity Proportioanl Relief Valve (direct acting)
PRB-8A-2D-Y-Z
PRB-8A-2C-Y-Z