Note: Data may vary by configuration. See CONFIGURATION section.
Cavity |
19A-3 (19AB-3) |
Rated Flow |
87.18 gpm
320 L/min |
Control Pilot Flow |
0.07 - 0.09 gpm
0.25 - 0.33 L/min |
Maximum Operating Pressure |
5000 psi
350 bar |
Valve Hex Size |
1-5/8 in.
41.2 mm |
Valve Installation Torque |
343 - 369 lbf-ft
465 - 500 Nm |
Adjustment Screw Internal Hex Size |
5/32 in.
4 mm |
Locknut Hex Size |
9/16 in.
14.27 mm |
Locknut Torque |
6 - 7 lbf-ft
9 - 10 Nm |
Weight |
2.8 lbs (Z=L)
1.27 kg (Z=L) |
This is a pilot-operated, spool-type reducing/relieving valve, it can be used in any application where a regulated pressure lower than system pressure is required. It allows bidirectional flow between port 2 and port 1. When the pressure at port 1 exceeds the pressure setting, the spool shifts to restrict flow at port 2, regulating the pressure at port 1. If the pressure at port 1 continues to rise above the valve setting, the spool shifts further to relieve excess pressure through port 3 (tank) until the set pressure is restored.
-
When X=33, the lowest pressure will be a bit higher than standard.
-
Please note the pressure differential between inlet and reducing port when select the proper adjustment range.
-
Pressure at port 3 adds directly to the valve setting at a 1:1 ratio.
-
Working parts are heat-treated and high-precision ground to increase hardness for long life.
-
A variety of seal kit materials for different applications, see seals information under Technical Reference.
-
Winner's cartridges pressure rating tested to the standard of the NFPA specification T2.6.1 and the fatigue rating's assurance and verification level is “90/90”.
-
WINNERcoat® Zinc-Nickel Plating is salt spray tested in accordance with DIN EN ISO 9227 for up to 1000 hours.
-
Winner guarantees that all products performance a 100% functional test before shipment.